M

FabricSheetType.SetMajorLayoutAsNumberWithSpacing

Description:
Sets the major layout pattern as NumberWithSpacing, while specifying the needed parameters for this pattern.

public void SetMajorLayoutAsNumberWithSpacing(
	double overallWidth,
	double minorStartOverhang,
	int numberOfWires,
	double spacing
)

Public Sub SetMajorLayoutAsNumberWithSpacing ( _
	overallWidth As Double, _
	minorStartOverhang As Double, _
	numberOfWires As Integer, _
	spacing As Double _
)

public:
void SetMajorLayoutAsNumberWithSpacing(
	double overallWidth, 
	double minorStartOverhang, 
	int numberOfWires, 
	double spacing
)

System.Double

overallWidth

The entire width of the wire sheet in the minor direction.
System.Double

minorStartOverhang

The distance from the edge of the sheet to the first wire in the minor direction.
System.Int32

numberOfWires

The number of the wires to set in the major direction.
System.Double

spacing

The distance between the wires in the major direction.

Autodesk.Revit.Exceptions.ArgumentException

The given value for overallWidth is not a number -or- The given value for minorStartOverhang is not a number -or- numberOfWires must range from 2 to 1000000. -or- The given value for spacing is not a number -or- The arguments are not consistent, please specify proper input values.
Autodesk.Revit.Exceptions.ArgumentOutOfRangeException

The given value for overallWidth must be greater than 0 and no more than 30000 feet. -or- The given value for minorStartOverhang must be between 0 and 30000 feet. -or- The given value for spacing must be greater than 0 and no more than 30000 feet.
Autodesk.Revit.Exceptions.DisabledDisciplineException

None of the following disciplines is enabled: Structural.