M

Pipe.Create

Description:
Creates a new pipe that connects to two connectors.

Remarks:
The new pipe will have the same diameter and system type as the start connector. The creation will also connect the new pipe to two component who owns the specified connectors. If necessary, additional fitting(s) are included to make a valid connection. If the new pipe can not be connected to the next component (e.g., mismatched direction, no valid fitting, and etc), the new pipe will still be created at the specified connector position, and an InvalidOperationException is thrown.

Overloads (3):

Create(Document,ElementId,ElementId,Connector,Connector)

Create(Document,ElementId,ElementId,Connector,XYZ)

Create(Document,ElementId,ElementId,ElementId,XYZ,XYZ)

public static Pipe Create(
	Document document,
	ElementId pipeTypeId,
	ElementId levelId,
	Connector startConnector,
	Connector endConnector
)

Public Shared Function Create ( _
	document As Document, _
	pipeTypeId As ElementId, _
	levelId As ElementId, _
	startConnector As Connector, _
	endConnector As Connector _
) As Pipe

public:
static Pipe^ Create(
	Document^ document, 
	ElementId^ pipeTypeId, 
	ElementId^ levelId, 
	Connector^ startConnector, 
	Connector^ endConnector
)

Autodesk.Revit.DB.Document

document

The document.
Autodesk.Revit.DB.ElementId

pipeTypeId

The ElementId of the new pipe type.
Autodesk.Revit.DB.ElementId

levelId

The level ElementId for the new pipe.
Autodesk.Revit.DB.Connector

startConnector

The first connector where the new pipe starts.
Autodesk.Revit.DB.Connector

endConnector

The second point of the new pipe.

Return Value The pipe. The pipe.

Autodesk.Revit.Exceptions.ArgumentException

The pipe type pipeTypeId is not valid pipe type. -or- The ElementId levelId is not a Level. -or- The connector domain is not Domain.Piping. -or- The points of startConnector and endConnector are too close: for MEPCurve, the minimum length is 1/10 inch.
Autodesk.Revit.Exceptions.ArgumentNullException

A non-optional argument was null
Autodesk.Revit.Exceptions.DisabledDisciplineException

None of the following disciplines is enabled: Mechanical Electrical Piping.
Autodesk.Revit.Exceptions.InvalidOperationException

Thrown when the new pipe fails to connect with the connector.